Trims settings page
Trims are used adjust the center position of a given stick axis. EdgeTX has the following time configuration options:
Reset - This resets all trim values to zero.
Trim Step: Defines the amount of increase/decrease in trim when the trim switch is pressed.
- Course = 1.6%
- Medium = 0.8%
- Fine = 0.4%
- Extra Fine = 0.2%
- Exponential = 0.2% near the center and the step value increases exponentially as the distance from the center increases.
Extended Trims: Increases the maximum trim adjustment value from ±25% to ±100%.
{% hint style="info" %} When switching from extended trims to normal trims, the extended trim value will remain until the trim is adjusted, then it will jump to the max/min normal trim value. {% endhint %}
Display trims: Option to display the numerical trim value on the trim bar. Options are:
- No - Does not display the numerical trim value on the trim bar
- Yes - Displays the numerical trim value on the trim bar once the trim is no longer at zero.
- Change - Momentarily displays the numerical trim value on the trim bar (2 seconds) once the trim is no longer at zero.