always move

Author: thinkyhead

Marlin/Configuration_adv.h

@@ -2831,8 +2831,6 @@
 
   //#define FILAMENT_LOAD_UNLOAD_GCODES           // Add M701/M702 Load/Unload G-codes, plus Load/Unload in the LCD Prepare menu.
   //#define FILAMENT_UNLOAD_ALL_EXTRUDERS         // Allow M702 to unload all extruders above a minimum target temp (as set by M302)
-
-  //#define FILAMENT_CHANGE_MENU_AT_BOTTOM        // Add the filament change menu to the bottom of the main menu instead of below temperature.
 #endif
 
 // @section tmc_smart

Marlin/src/lcd/menu/menu_main.cpp

@@ -340,7 +340,7 @@ void menu_main() {
     SUBMENU(MSG_TEMPERATURE, menu_temperature);
   #endif
 
-  #if ENABLED(ADVANCED_PAUSE_FEATURE) && DISABLED(FILAMENT_CHANGE_MENU_AT_BOTTOM)
+  #if ENABLED(ADVANCED_PAUSE_FEATURE)
     FILAMENT_CHANGE_ITEM();
   #endif
 
@@ -503,10 +503,6 @@ void menu_main() {
     });
   #endif
 
-  #if ALL(ADVANCED_PAUSE_FEATURE, FILAMENT_CHANGE_MENU_AT_BOTTOM)
-    FILAMENT_CHANGE_ITEM();
-  #endif
-
   END_MENU();
 }