NOTE: Be aware of your material shrinkage. This is important for the top lid piece which may be too small if not scaled up. I generally scale up to 100.58 for ABS and 100.45 for ASA.
 Top mounted clamps all you to tilt all the way to 90 degrees, but will not tilt as flat. |
 Under mounted clamps will tilt almost flat, but not quite to 90 degrees. |
 |
 |
 |
 You can reach the tightening bolts from above the lid. |
 Remove the red support piece |
-
Notes
- Don't forget to account for your material shrinkage. I recommend scaling up all the pieces and not just the lid piece. I scaled mine to 100.58 in X and Y (Z isn't an issue usually).
- There is a small support piece on the lid that needs to be removed.
- Glue in the [a]_mini12864_case_front_accent.stl into mini12864_case_front.stl before pressing in the heat sets.
- m3x8 to mount the clamps to the lid. Recommend button heads if using the underneath mounting clamps.
- m3x8 to mount the swingarms to the 12864 case. Recommend button heads if using the underneath mounting clamps.
- m3x10 or 12 to clamp the swingarms to the clamps.
- m3x16 to attach the lid to the 12864 case sides.
-
Acknowledgements
- Annex Parts
- This backpack lid is modified from the Annex K3.
- Their license is located at https://github.com/Annex-Engineering/ANNEX-Engineering-License-Agreement
- K3 repository is located at https://github.com/Annex-Engineering/Gasherbrum-K3
- Voron Parts
- The Voron license is GNU General Public License v3.0
- The Voron 2.4 Repository is located at https://github.com/VoronDesign/Voron-2
- Annex Parts