The JDH Probe is an ongoing project to create a printer-agnostic DIY bed probing solution for FDM printers. The board is currently designed as a drop-in replacement for the factory FLSUN leveling module, but we hope to extend the board's capabilities (such as adding ADXL345 support) and to make it a viable option for hobbyists and DIYers alike.
The FLSUN clone housing for the board can be found on Printables.com.
This housing uses all the same hardware as the factory probe, they are listed below:
- 4x M2x4 Screws
- 1x M3x8 Screw
- 1x Probe Board
- 1x 20mm x 10mm x 4mm Magnet with center counter-sunk hole. (N35 is sufficient, N52 is recommended)
Note: The factory probe uses all self-tapping screws. These are not required to be self-tapping