This is a configuration starter for Marlin 1.1.9 on the Anet A4 Delta 3d printer. Any previous versions will be kept in a branch with the naming convention Marlin-x.x.x.
-
DELTA_DIAGONAL_ROD should be set to the length of your rods.
- If your parts turn out larger or smaller than expected then this should be increased or decreased respectively
-
DELTA_RADIUS should be adjusted if your nozzle doesn't navigate from the center to the outside in a flat line
- If the nozzle is too high in the center an goes towards the bed increase delta radius
- If the nozzle is too low in the center and goes away from the bed decrease the delta radius